Duplo DFC-12 User Manual

16
10. LOADING PAPER ACCORDING TO COLLATION MODE
10-2. Loading paper for interleaving mode
10-3. Loading paper for alternative mode
Páginas clasificadas
Page 1
Page 2
Page 3
Page 4
Page 5
Page 6
Page 7
Page 8
Page 9
Páginas para
intercalado
Intercalado
Intercalado
Intercalado
Intercalado
Páge 1
Page 2
Page 3
Page 4
Page 5
Page 6
• Interleaves are inserted after every
specified number of sets have been col-
lated.
• Interleaves are inserted after every 200
sets maximum.
Load the interleaves at the bottommost
bin.
Load in bin 12 for the DFC-12 and in bin
10 for the DFC-10. See the right figure for
details.
• For details on the loading direction of paper
and paper ejection direction, refer to "10-1.
Loading paper for normal mode" ( page
15).
• Interleaving mode is shown as "Int. Lv." in the
LDC window.
Load the same paper on continuing even
and odd (top and bottom) bins from the
top in order (1st and 2nd bins, 3rd and
4th bins....11th and 12th bins) for colla-
tion.
Paper feed starts from either bin (odd or
even) of each pair.
If paper runs out in a bin, paper feed will
start from the other bin in the pair. By re-
plenishing paper in the empty bin, continu-
ous operations can be ensured.
• For details on the loading direction of paper
and paper ejection direction, refer to "10-1.
Loading paper for normal mode" ( page
15).

Duplo DFC-12 Specifications

General

Brand	Duplo
Model	DFC-12
Category	Printer Accessories
Language	English