Duplo DUPRINTER DP-440 - Page 252

254
c HELP Mode Function and Operation Procedures
chap.7
H-32
(1) Adjustment / specification settingHELP mode
ABCD Item Setting
0***
1***
*0**
1st-speed (about 45 rpm)
*1**
JOG speed (about 15 rpm)
**0*
Yes
**1*
No
No sort mode
Sort mode
***0
Default Sort mode setting
***1
0000
Initial value
Not used
Selecting the print speed for
the first sheet after master
make is completed.
Master ejection failure
detection
ePress the [=] key.
The correction amount will be memorized in the battery PCB unit's
EEPROM. During memorization,"SAVE" will be displayed.
Do not turn off the power before the "SAVE" display has disappeared.
1. Functions
(1)
Confidential Safeguard,First print setting,Master ejection
failure detection,Default Sort mode setting
¡ Following items are indicated.
A : ( Not used )
B : First print setting
C : Master ejection failure detection
D : Default Sort mode setting
(1) Confidential Safeguard,First print setting,Master ejection
failure detection,Default Sort mode setting
¡During memorization:
IMPORTANT :
2. Operation procedure
Accessing HELP modes
a See page 213
qAccess HELP mode H-32, and press the PRINT key.
HELP-032
Spec setting
0000
wUse the [0] and [1] numeric keys to enter a 4-place binary
value for the desired correction amount.
See the table below for 4-place binary values and the corresponding
correction amounts.
a To exit the HELP mode
: Turn the power switch OFF.
a
To access another HELP mode
:
Enter the desired mode number
using the numeric keys.
rPress the STOP key.
The HELP mode selection display will reappear.
A B C D
- SAVE -