35
z Scanner Section
chap.2
Platemaking Area for the Book Shadow Erasing Mode
When the platemaking is performed in the book shadow erasing mode, the platemaking area is limited 3
mm inner than the normal platemaking area as shown in the figure. 15mm is left in the central section
(stitching section).[Shadow erasing as desired is not included.]
* During multiple image printing, the book shadow erasing mode can not be used.
Platemaking Area for the Selected Paper
2The platemaking area varies depending on the selected paper size as shown below.
* When the magnification error is 0 in the pei path
direction or in the line progression direction, the
size for the same size (1:1) platemaking is shown.
To Next Page
Loading...
Need help?
General