275
c HELP Mode Function and Operation Procedures
chap.7
H-55
(1) Adjustment / specification settingHELP mode
ABCD Item Setting
0***
Ink check
1***
No ink check
*0**
*1**
**0*
Activated
**1*
Deactivated
Stops if jam occurs twice on the left side
Stops if jam occurs once on the left side
***0
***1
0000
Setting of ink check, that
triggers ink replenishment if
no ink is detected at printing
start
Not used
Interlock: emergency stop if
scanner unit or ejection box
open
Signal jam setting
Initial value
ePress the [=] key.
The correction amount will be memorized in the battery PCB unit's
EEPROM. During memorization,"SAVE" will be displayed.
Do not turn off the power before the "SAVE" display has disappeared.
1. Functions
(1) Ink check when starting printing,Emergency stop,Signal jam setting
¡Following items are indicated.
A : Ink check when starting printing
B : (Not used)
C : Emergency stop (interlock)
D : Signal jam
(1) Ink check when starting printing,Emergency stop,Signal jam setting
¡During memorization:
IMPORTANT :
2. Operation procedure
Accessing HELP modes
a
See page 213
qAccess HELP mode H-55, and press the PRINT key.
wUse the [0] and [1] numeric keys to enter a 4-place binary
value for the desired correction amount.
See the table below for 4-place binary values and the corresponding
correction amounts.
a
To exit the HELP mode
: Turn the power switch OFF.
a
To access another HELP mode
:
Enter the desired mode number
using the numeric keys.
rPress the STOP key.
The HELP mode selection display will reappear.
A B C D
- SAVE -
To Next Page
Loading...
