Duplo DUPRINTER DP-440 - Page 290

292
c HELP Mode Function and Operation Procedures
chap.7
H-81
(1) Adjustment / specification settingHELP mode
A B C D Item Setting
00**
445mm
01**
10**
11**
**0*
**1*
***0
Tape cluster 4 motor setting
***1
0010
Factory setting
Tape cluster long tape setting
Not used
395mm
335mm
280mm
old type
new type
ePress the [=] key.
The correction amount will be memorized in the battery PCB unit's
EEPROM. During memorization,"SAVE" will be displayed.
Do not turn off the power before the "SAVE" display has disappeared.
1. Functions
(1)
Tape cluster Long tape, Tape cluster 4 motor setting
¡Following items are indicated.
A ,B : Tape cluster Long tape setting
C : Tape cluster 4 motor setting
D : (Not used)
(1) Tape cluster Long tape, Tape cluster 4 & new tape setting
¡During memorization:
IMPORTANT :
2. Operation procedure
Accessing HELP modes
a See page 213
qAccess HELP mode H-81, and press the PRINT key.
HELP-081
Spec setting
1111
wUse the [0] and [1] numeric keys to enter a 4-place binary
value for the desired correction amount.
See the table below for 4-place binary values and the corresponding
correction amounts.
a To exit the HELP mode
: Turn the power switch OFF.
a
To access another HELP mode
:
Enter the desired mode number
using the numeric keys.
rPress the STOP key.
The HELP mode selection display will reappear.
A B C D
- SAVE -