294
c HELP Mode Function and Operation Procedures
chap.7
H-86
(1) Adjustment / specification settingHELP mode
ABCD Item Setting
0001
Set amount
Smaller the arching dimension
Larger the arching dimension
0000
•
•
•
•
•
•
•
•
1110
1111
ePress the [=] key.
The correction amount will be memorized in the battery PCB unit's
EEPROM. During memorization,"SAVE" will be displayed.
Do not turn off the power before the "SAVE" display has disappeared.
1. Functions
(1)
Paper feed length adjustment
(1)
Paper feed length adjustment
¡During memorization:
IMPORTANT :
2. Operation procedure
Accessing HELP modes
a
See page 213
qAccess HELP mode H-86, and press the PRINT key.
wUse the [0] and [1] numeric keys to enter a 4-place binary
value for the desired correction amount.
See the table below for 4-place binary values and the corresponding
correction amounts.
a
To exit the HELP mode
: Turn the power switch OFF.
a
To access another HELP mode
:
Enter the desired mode number
using the numeric keys.
rPress the STOP key.
The HELP mode selection display will reappear.
A B C D
- SAVE -
To Next Page
Loading...
