DuraLabel.com | 800.788.5572
3.3 Using a Parallel Cable | 21
CONNECTING THE PRINTER
F. Select Install printer drivers on the Driver Wizard window that appears and
click Next.
G. Select Graphic Products DuraLabel PRO or DuraLabel PRO 300 on the Specify
Printer Model window that appears and click Next.
H. Select the LPT1 port on the Specify Port window that appears and click Next.
I. Select Printer Name, set the printer as default, and choose printer sharing
options on the Specify Printer Name window that opens, then click Next.
J. Review information on the Completing the Seagull Driver Wizard window that
opens and click Finish if the information is correct. If it isn’t correct, revise the
selections made in previous steps and click Finish when the window’s information
is accurate.
K. A Driver Wizard Completed Successfully window appears, confirming the printer
driver installation was completed successfully. Click Close.
L. The previous window closes and a Completing the DuraLabel Driver Setup Wizard
window appears. Click Finish to complete the new driver installation.
FIGURE 8 Specify Printer Model for
Driver Installation.
FIGURE 9 Select LPT1 port when using a
parallel cable to install a driver.
FIGURE 10 Printer Name, Default and
Sharing Status
FIGURE 12 Driver Wizard Completed
Successfully Window
FIGURE 11 Completing the Seagull
Driver Wizard
FIGURE 13 Click Finish on the Completing
the DuraLabel Driver Setup Wizard window.
To Next Page
Loading...
