DuraLabel PRO 300 - Configuring Printer Drivers for Optimal Output; Continuous Vinyl Printing Instructions

DuraLabel.com | 800.788.5572 4.1 Continuous Vinyl Printing Instructions | 23
 &RQÀJXULQJ3ULQWHU'ULYHUV
IMPORTANT! 3HUIRUPWKHGULYHUFRQÀJXUDWLRQEHIRUHRSHQLQJWKHGRFXPHQW\RXSODQ
to print.
A. Click Start > Devices and Printers*. A Devices, Printers and Faxes window
appears.
*NOTE:,I\RXGRQRWÀQG'HYLFHVDQG3ULQWHUVLQ\RXU6WDUWPHQX\RXFDQDFFHVV
it in your Control Panel.
B. Right-click the Graphic Products DuraLabel PRO/PRO 300 icon and select
Printing preferences. A Printing Preferences dialog box appears.
C. Click the Page Setup tab and select Landscape or
Portrait, depending on your label’s orientation.
D. If your label size is not shown in the Stock Name
drop-down menu, click Edit and set the size that
matches your label size.
NOTE: Your DuraLabel PRO/PRO 300 print drivers are
preset to several print values. Please be aware that
changing a preset value is not fully supported by all
software programs. For best results, make changes to
preset values from the Devices and Printers window.
4.1 Continuous Vinyl Printing Instructions
Your printer driver has been preset to common settings to reduce the steps needed to
set them manually. You can change your settings by following these steps:
A. To configure the driver, set the cutter, select the Stock tab, then select Continuous
from the Type drop-down menu under “Media Settings.”
B. To cut after each label, select Cut from the Post-Print Action drop-down menu and
select After Every Page from the Occurrence drop-down menu.
C. To cut after each job, select Cut from the Post-Print Action drop-down menu and
select After Job from the Occurrence drop-down menu.
D. Click Apply, then OK.
FIGURE 1 Printing Preferences dialog
box with Page Setup tab selected