28 | 6.1 Label Creation with Your Word Processor
DuraLabel.com | 800.788.5572
6. Label Creation
This section describes how to create labels using Microsoft
®
Word. Variations may occur
among different versions of Word, but basic principles are the same. The DuraLabel
PRO/PRO 300 is designed to work with any currently supported Windows software and
should work with the software installed on your computer. Microsoft Word 2003 and
2010 were used to describe many procedures in this Guide.
NOTE: Navigation may vary depending on your version of Word, but the tools will be the
same.
The information in this section assumes your printer has been properly installed and is
connected in the online mode.
6.1 Label Creation with Your Word Processor
DuraLabel PRO/PRO 300 printers operate off a standard Windows driver that allows
access to a wide variety of software packages.
6.1.1 USING TEMPLATES
IMPORTANT! If you do not follow this step, you will need to create all labels from
scratch.
The DuraLabel PRO/PRO 300 provides a variety of templates you can install from the
installation CD start-up screen. Click on Install Templates & Symbols and follow the
instructions. When installation is complete, templates and symbols will be accessible from
a folder titled My Documents\DLP Templates & Symbols.
To use a template, open Microsoft Word, select Open and browse the DLP Templates
& Symbols folder. Any template you choose has been set up to print correctly on the
DuraLabel PRO/PRO 300 printer with minimal augmentation.
To Next Page
Loading...
