40 | 8.2 Cutter
DuraLabel.com | 800.788.5572
CLEANING AND GENERAL MAINTENANCE
C. Run the swab back and forth across the cutter several times to remove any buildup
of labeling adhesive. Wait a few seconds for the alcohol to dry.
D. Replace the cutting mechanism, inserting the tabs on the sides of the cutter, into
the slots as shown below.
NOTE: Replace wires through the open slot from where they’re connected, being
careful not to pinch them.
)LJXUH 5HSODFHFXWWHUE\ÀWWLQJWDEVLQWRWKHVORWVSURYLGHG
To Next Page
Loading...
