Set-up
Operating manual 281 Version 06.0 - 05/201356
7.6 Setting the working height
The working height is continuously adjustable between 750 and
900 mm (clearance between the floor and upper edge of the table
plate).
Figure 33: Setting the working height
1. Loosen all four screws (1) on the head sections.
2. Set the table plate to the desired height.
Important: Pull out or push in the table plate evenly at both
sides to prevent it from jamming.
3. Tighten the screws (1) on the head sections.
To Next Page
Loading...
