About this manual
Operating manual 281 Version 06.0 - 05/20134
1.4 Symbols used
Correct setting
Specifies the correct setting.
Faults
Specifies the faults that can occur due to an incorrect setting.
Steps to be performed when operating the machine (sewing
and equipping)
Steps to be performed for servicing, maintenance, and
installation
Steps to be performed via the software control panel
The individual steps are numbered:
1. First step
2. Second step
The sequence of the steps must always be followed.
Result of performing an operation
Change to the machine or in the display.
Important
Special attention must be paid to this point when performing a step.
Information
Additional information, e. g. on alternative operating possibilities.
Sequence
Specifies the work to be performed before or after a setting.
It is vital that this sequence is adhered to.
Reference
A reference is provided to another place in the text.
To Next Page
Loading...
Need help?
General
