5.3 Fitting the pedal
–
Attach the pedal 2 to the stand brace 1.
–
For ergonomic reasons align the pedal 2 as follows:
The centre of the pedal must be approximately under the needle.
There are slots in the stand brace 1 to help align the pedal.
–
Screw the ball pins from the middle to the front hole in the lever 5.
–
Attach pedal linkage 3.
–
Slightly undo screw 4.
–
Adjust the height of the pedal linkage 3 as follows:
when released the pedal 2 should be at an angle of about 10°.
–
Tighten screw 4.
5.4 Attaching the knee lever
The knee lever 6 mechanically raises the sewing foot.
–
Attach the knee lever 6.
–
Undo the screws on the joint 7.
Adjust the knee lever so that it can be conveniently
operated with the right knee.
Retighten the screws on joint 7.
–
Undo screw 8.
–
Align the knee-pad.
–
Retighten screw 8.
Caution !
The knee lever 6 must be detached before the machine head is folded
back.
14
To Next Page
Loading...
