3. Assembling the stand
3.1 Assembling the stand components
–
Assemble the individual stand components as s hown in the
illustration.
3.2 Assembling the table plate and attaching it to the stand
–
Insert the upper-part support 1 in the hole in the table plate.
–
Insert the hinge bases 3 for the machine head into the recess in the
table plate 4 and screw in place.
–
Insert the rubber corner 8.
–
Screw the drawer 5 with its mountings under the table plate on the
left-hand side.
–
Screw the main switch 12 under the table plate on the r ight-hand
side.
–
Screw the cable conduit 10 under the table plate behind the main
switch 12.
–
Screw the holder 9 for the mains-lead cleat under the table plate
behind the cable conduit 10.
–
Screw the sewing-lamp transformer 11 (optional equipment) under
thetableplate.
–
Attach the table plate 4 to the stand with woodscrews (B8 x 35)
(see sketch for position).
–
Insert the reel stand 7 in the hole in the table plate and secure it
with the nuts and washers.
Fit and align the yarn-reel and unwinding holders.
The yarn-reel holder and the unwinding arm must be vertically in
line.
–
Screw the holder for the oil-can 6 onto the left-hand stand brace.
7
To Next Page
Loading...
