Changing manufacturer-level parameter values
Entering the manufacturer-level code number
–
Turn off the main switch.
–
All plugs must be plugged in to the sewing-drive control.
–
Press and hold down the “P”key.
–
Turn on the main switch. “C-0000” appears in the display.
–
Release the “P”key.
–
Enter code no. 3112 with number keys 0 to 9.
–
Press the “E” key. The first manufacturer-level parameter F-200 is
displayed
–
Continue as for “Selecting parameters and changing values”
Caution:
The changed parameter values are not saved unless a complete seam
is sewn after leaving programming level, i.e. the pedal is pushed
forwards and then all the way back. If the drive is switched off straight
after leaving programming level, the changes are lost.
6.11.6 Table of machine-specific parameters of the 6F82FA control
See section 6.11.3.
Caution !
Great care must be taken when changing parameter values, as an
incorrectly-set drive control may damage the machine. A master reset
restores all parameters to their pre-set values. See section 6.12.
32
To Next Page
Loading...
