6.11.4 Setting parameter values with the V810 operating panel
Changing technician-level parameter values
Entering the technician-level code number
–
Turn off the main switch.
–
All plugs must be plugged in to the sewing-drive control.
–
Press and hold down the “P”key.
–
Turn on the main switch. “C-0000” appears in the display.
–
Release the “P”key.
–
Enter code no. 1907.Pressthe“+”or“-” keys to alter the value of
the flashing digit. Press the “>>” key to move to the next digit.
–
Press the “E” key. The first technician-level parameter F-100 is
displayed.
Selecting parameters and changing values
–
Press the “+” and “-” keys to s elect the next or preceding
para me ter.
–
The parameter can be entered direct with the “>>”, “+”and “-”keys.
–
Press the “E” key. The value of the selected parameter is
displayed.
–
Press the “+” and “-” keys to change the parameter value.
–
Press the “E” key to display the next parameter
or the “P” k ey to display the same parameter.
Saving changed parameter values
–
Press the “P” key to terminate programming.
–
Sew a complete seam, i.e. push the pedal forward and then fully
back. The change is saved.
–
If no seam is sewn, the change is lost.
–
Press the “P” key again to return to programming level.
Changing manufacturer-level parameter values
Entering the manufacturer-level code number
–
Turn off the main switch.
–
All plugs must be plugged in to the sewing-drive control.
–
Press and hold down the “P”key.
–
Turn on the main switch. “C-0000” appears in the display.
–
Release the “P
”key.
–
Enter code no. 3112.Pressthe“+”or“-” keys to alter the value of
the flashing digit. Press the “>>” key to move to the next digit.
–
Press the “E” key. The first manufacturer-level parameter F-200 is
displayed
–
Continue as for “Selecting parameters and changing values”
30
To Next Page
Loading...
Need help?
General
