DURKOPP ADLER 512 - Referencing the Machine; Selecting the Seam Appearance; Scaling the Axes; Scaling the X Axis

Settings via the software
Operating Manual 512/532 Version 00.0 - 12/2013 37
5.3 Referencing the machine
1. Press the Ready button.
 The button LED illuminates.
2. Press the Ready button.
 The button LED goes out.
5.4 Selecting the seam appearance
Prerequisite:
• Machine is in programming mode, Ready button LED is off.
1. Press the +/– Function buttons until the seam appearance
number is shown in the Function display.
5.5 Scaling the axes
Important
Changes to the axes only take effect temporarily. For information
on making permanent changes and relocating the seam
appearance, see  5.14 Saving seam appearances, p. 42.
5.5.1 Scaling the X axis
1. Press the Select button until the X axis symbol LED
illuminates.
2. Press the +/– Function buttons until the desired X axis value
is reached. 100 % corresponds to the specified dimensions of
the selected seam appearance.
ATTENTION
Damage to the needle if the size of the seam appearance
does not match the clamping foot.
Check the clamping foot and adjust if necessary.