DURKOPP ADLER 512 - Scaling the y Axis; Recalculate the Button Hole Clearance (Class 532)

Settings via the software
Operating Manual 512/532 Version 00.0 - 12/201338
5.5.2 Scaling the Y axis
1. Press the Select button until the Y axis symbol LED
illuminates.
2. Press the +/– Function buttons until the desired Y axis value
is reached. 100 % corresponds to the specified dimensions of
the selected seam appearance.
5.5.3 Recalculate the button hole clearance (class 532)
The button hole clearance is preset to 3.4 mm (3.4 mm = 100 %).
The button hole clearance can be set by changing the percentage
value.
Button hole
clearance [mm]
Value [%]
Button hole
clearance [mm]
Value [%]
Button hole
clearance [mm]
Value [%]
1 29 2.9 85 4.8 141
1.1 32 3 88 4.9 144
1.2 35 3.1 91 5 147
1.3 38 3.2 94 5.1 150
1.4 41 3.3 97 5.2 153
1.5 44 3.4 100 5.3 156
1.6 47 3.5 103 5.4 159
1.7 50 3.6 106 5.5 162
1.8 53 3.7 109 5.6 165
1.9 56 3.8 112 5.7 168
2 59 3.9 115 5.8 171
2.1 62 4 118 5.9 174
2.2 65 4.1 121 6 176
2.3 68 4.2 124 6.1 179
2.4 71 4.3 126 6.2 182
2.5 74 4.4 129 6.3 185
2.6 76 4.5 132 6.4 188
2.7 79 4.6 135 6.5 191
2.8 82 4.7 138