DURKOPP ADLER 512 - Recalculate the Bartack Dimensions (Class 512); Setting the Speed; Checking the Seam Appearance

Settings via the software
Operating Manual 512/532 Version 00.0 - 12/2013 39
5.5.4 Recalculate the bartack dimensions (class 512)
The following formula is used for converting the preset dimensions
to the desired dimensions:
Value to be set =
(100 % : preset dimension) * desired value
Example Preset dimension in the X direction = 16 mm
Desired value in the X direction = 10 mm
Value to be set = (100 % : 16 mm) * 10 mm = 62.5 %
5.6 Setting the speed
Important
Changes to the speed only take effect temporarily. For information
on making permanent changes see  5.14 Saving seam
appearances, p. 42.
1. Press the Select button until the Speed symbol LED illuminates.
2. Press the +/– Function buttons until the desired speed is
reached.
5.7 Checking the seam appearance
1. Press the Select button until the Seam appearance form
symbol LED illuminates.
 The Program display shows the current seam appearance
form.
2. Press the Ready button to confirm the seam appearance.
 The Ready button LED illuminates.
3. Press the foot pedal forwards.
 The clamp lowers.
4. Press the +/– Function buttons to sew 1 stitch respectively.
 The Function display shows the current number of stitches.
5. Press the Reset button.
 The clamp raises.
6. Press the Select button until the Seam appearance form
symbol LED illuminates.