DURKOPP ADLER 512 - Loading the Main Program; Loading Seam Appearances

Settings via the software
Operating Manual 512/532 Version 00.0 - 12/2013 57
5.24.1 Loading the main program
1. Switch on the controller.
2. Plug in the USB stick.
3. Press the USB button and wait approx. 3 seconds.
4. Press the Memory button.
5. Use the +/– Function buttons to set a value of 5 in the Function
display.
6. Press the Select button.
 The download into the controller starts.
Important
The download is finished when no more values are shown in the
Function display. You must now wait at least 25 seconds before
continuing, otherwise the controller can be damaged!
7. Switch off the controller.
8. Pull out the USB stick.
5.24.2 Loading seam appearances
1. Switch on the controller.
 The current software version is briefly shown in the display.
2. Plug in the USB stick.
3. Press the USB button and wait approx. 3 seconds.
4. Press the Memory button.
5. Press the P5 button.
 The download into the controller starts. Duration is approx.
4min.
6. Press the Reset button.
7. Pull out the USB stick.
 The software transfer is complete.