DURKOPP ADLER 512 - Page 4

Contents
Operating Manual 512/532 Version 00.0 - 12/20132
5.8 Changing the seam appearance .........................................................40
5.9 Bobbin winding ....................................................................................40
5.10 Sewing.................................................................................................41
5.11 Counter................................................................................................41
5.12 Pausing sewing ...................................................................................42
5.13 Disabling standard seam appearances ...............................................42
5.14 Saving seam appearances.................................................................. 42
5.14.1 Assigning the memory buttons ............................................................43
5.14.2 Sewing with the memory buttons ........................................................44
5.14.3 Deleting the memory button assignments ...........................................44
5.15 Saving seam appearance sequences .................................................44
5.16 Sewing with a seam appearance sequence........................................ 45
5.17 Deleting a seam appearance sequence..............................................45
5.18 Finishing sewing..................................................................................46
5.19 Editing parameters in memory ............................................................46
5.19.1 Editing parameters at the M1 level...................................................... 46
5.19.2 Editing parameters at the M2 level...................................................... 47
5.20 Resetting parameters to factory defaults.............................................48
5.21 Externally editing seam appearances ................................................. 49
5.22 Working with a USB stick ....................................................................51
5.23 Error messages ...................................................................................53
5.24 Loading software from a USB stick .....................................................56
5.24.1 Loading the main program ..................................................................57
5.24.2 Loading seam appearances ................................................................57
5.24.3 Setting parameter U085 (Class 532)................................................... 58
5.24.4 Checking the software version ............................................................58
6 Maintenance.......................................................................................59
6.1 Cleaning and checking ........................................................................ 59
6.2 Lubrication...........................................................................................61
7 Seam appearances............................................................................65
7.1 Standard seam appearances for class 512.........................................65
7.2 Standard seam images for class 532 ..................................................69
8 Setup ..................................................................................................71
8.1 Checking the scope of delivery ...........................................................71
8.2 Removing the transport securing devices ...........................................71
8.3 Assembly.............................................................................................72
8.3.1 Checking the table plate......................................................................72
8.3.2 Assembling the frame..........................................................................72
8.3.3 Completing the table plate...................................................................73
8.3.4 Mounting the upper section support ....................................................74
8.3.5 Setting the working height ...................................................................75
8.3.6 Mounting upper machine section ........................................................76