2.11.2 Setting the corner knives (Manual corner knife station)
With the 745-34 the slanted pockets result from the seam offset
between the two seam rows programmed at the control panel.
Caution: Danger of injury!
Switch off the main switch.
Set the corner knives only with the sewing unit switched off.
–
Swing the corner knife station out (see chapter 2.11.1)
Setting the angle of the corner knives
The angle of the corner knife is set by turning the knife blocks 2 and 4.
–
Loosen the screws 1 and 3.
–
Turn the knife blocks 2 and 4 equally.
–
Tighten the screws 1 and 3.
–
Set the angle at the rear knives correspondingly.
Height of the corner knives
The corner knives are not height-adjustable.
The knives always cut completely through.
Corner knife incision (offset)
The slants of the pockets result from the offset of the left and right
corner knife. The right corner knife is a stationary one, the left knife is
set according to the required offset.
–
Basic position (sewing of straight pocket corners):
The edges 1 and 2 are flush.
Adjustment by dial 5 or 6.
–
Offset (sewing of slanted pocket corners)
The left corner knife is s et to the front or to the back by the desired
value by means of dial 5 (front knife) and dial 6 (rear knife).
–
Swing the corner knife station in (see chapter 2.11.1).
28
To Next Page
Loading...
Need help?
General
