2.16.11 Working method B with set of parts “Pocket bag on flap”
The set of parts allows the simultaneous attaching of two pocket bag
halves when sewing the piping.
Flap and pocket bag are separated before sewing so that the light
barrier scans the flap length only. This manufacturing method does not
require the subsequent attaching of the pocket bag to the piping
projection. Thus the pocket opening remains flat and
displacement-free.
Order No. Set of parts “Pocket bag on flap” 0745 597874
Standard checking
–
In the machine parameters the mode “Pocket bag on flap” has to be
set. (See Programming Instructions, chapter 7.2) The lifted left
clamp moves to the loading position 10 mm further to the left.
Adjust the stops according to the Service Instructions chapter 4.4.
Select the mode “Pocket bag on flap” (See Programming
Instructions, chapter 7.2)
–
In the pocket parameters the parameter “Blowing of pocket
bag/piping” has to be set to mode 5 “ Blowing of pocket bag on
flap”. For selecting the parameter “Blowing of pocket bag/piping”
see Programming Instructions, chapter 6.4.
–
The stroke of the lifted left feeding clamp must not exceed 15 mm
(standard 20 mm). For adjusting the feeding clamp stroke see
Service Instructions chapter 4.3.
–
When working with this set of parts the front positioning point must
be used to guarantee that flap and pocket bag are securely
separated when running into the folder.
–
The rear marking lamp and the rear flap stop have to be set to the
flap length to be sewn.
–
In order to guarantee a trouble-free sewing process the pocket bag
mustlieatleast10mminfrontoftheflap.Thepipingprojection
must not exceed 10 mm as well.
1
83
To Next Page
Loading...
Need help?
General
