2.15.1 Working method A (Production of trousers)
Possible processing variants
–
Front trousers pockets with underlaid pocket bag.
–
Hind trousers pockets with or without flap, with underlaid pocket
bag.
–
Hind trousers pockets with or without flap, with automatically fed
reinforcement strip.
Positioning method
Example: Hind trousers without flap, with underlaid pocket bag
1
st
step:
–
Select the pocket program at the control panel.
–
Push the pocket bag under pocket bag clamp 1 and position at the
markings 2.
As markings you can use e.g. adhesive tape attached to the fabric
sliding plate.
2
nd
step:
–
Position the hind trousers at the “Rear positioning point” 5 and the
marking 6.
–
Touch the left pedal.
The hind trousers is clamped in its position by the fabric
downholder 3 and the waistband clamp 4.
–
Smooth out the clamped hind trousers in the dart area.
–
If additionally equipped with vacuum:
Step the left pedal down as far as it will go and hold it stepped.
The vacuum is switched on.
3
rd
step:
–
Touch the left pedal.
The feeding clamps run to the front and lower onto the workpiece.
–
Position the piping strip 8 on the feeding clamps flush with the front
edges 9.
The alignment of the different types of piping on the feeding clamps
is described more precisely in the following.
See“Positioningthepipingstrip”.
–
Touch the left pedal.
The folder 7 lowers.
–
Touch the left pedal once again.
Thesewingcyclestarts.
34
To Next Page
Loading...
Need help?
General
