2.16.12 Zipper feeders for method B
Zipper feeders are available for the processing of cut-to-length
zippers, without slider, total width 24 mm, chain w idth approx. 4 mm, in
four different variants:
Order No.: 0745 597764
Right zipper feeder, in case of ready-made pocket c hain inside,
in conjunction with feeding device 0745 517574
Order No.: 0745 597774
Left zipper feeder, in case of ready-made pocket chain inside,
in conjunction with feeding device 0745 507564
Order No.: 0745 597784
Right zipper feeder, in case of ready-made pocket c hain outside,
in conjunction with feeding device 0745 517574
Order No.: 0745 597794
Left zipper feeder, in case of ready-made pocket chain outside,
in conjunction with feeding device 0745 517564
Precondition
In the pocket parameters the parameter “Flap feeding mode”
must be set to mode 2 “Flap feed sw ivelled in during the sew ing
operation”.
(See Programming Instructions, chapter 6.4)
Function and operation
–
Cut the zipper to length.
–
Push the cut-to-length zipper 1 into the guide bar 2 up to a
positioning mark fitted on the rest table (thin adhesive tape).
–
If required, position and feed pocket bag and start the sewing
cycle.
86
12
To Next Page
Loading...
Need help?
General
