Caution: Danger of injury!
Do not reach into the working area of the positioning device when
triggering the individual steps of the positioning process.
Positioning and starting the sew ing cycle
With piping incision
1. Position the piping strip at the front stop 21 or at the rear stop 22.
Position the piping strip at the lateral stop 23.
2. Step the right pedal to the back and hold it stepped down.
The feeding device 13 opens.
Position flap 14 at stop 10 of the feeding device.
When sewing pockets w ith pipings on both sides position loop
and facing on the feeding device, too.
3. Release the right pedal.
The feeding device 13 closes.
4. Push the pocket bag 16 under the pocket bag clamp 15 and align
according to the positioning marks.
As positioning marks you can use e.g. adhesive tapes attached to
the fabric sliding sheet.
5. Align the hind trousers according to positioning method a) or b) at
the positioning marks 4 and 8 as well as 5 and 9.
6. Step forward on the left pedal.
Downholder 20 and waistband clamp 19 lower and clamp the hind
trousers in its position.
Smooth the clamped hind trousers out to the side and to the front.
7. Step forward on the left pedal.
The vacuum is switched on.
8. Step forward on the left pedal.
The piping is cut and picked up.
The transport carriage moves to the loading position.
The feeding clamps lower.
52
To Next Page
Loading...
Need help?
General
