Marking lamps
112 Service Instructions 745-35-10 S/745-35-10 A - 02.0 - 04/2017
Fig. 95: Aligning the laser modules (2)
Information
Laser module (9) marks the seam beginning, laser module (8) marks the
middle of the pocket opening, and laser module (7) marks the seam end.
Proper setting
Markings (3) and (4) must be aligned with the cutting line (2) (middle of the
pocket opening).
The distance between the middle of the pocket opening and the edge of
the sliding plate (measuring line) must be 100 mm.
To align the laser modules:
1. Loosen clamping nuts (12) and (13).
2. Align distance and angle of the laser module with the cutting line (2)
by shifting and turning.
3. Tighten clamping nuts (12) and (13).
4. Loosen clamping nut (10).
5. Align the laser line by turning laser module (11).
6. Re-tighten clamping nut (10).
Important
After adjusting the laser modules, make sure to follow the steps listed
below:
• Check the markings and their alignment relative to the middle of the
pocket ( p. 113)
• Observe the maximum sewing area
(7) - Laser module seam end
(8) - Laser module middle of the pocket opening
(9) - Laser module seam beginning
(10) - Clamping nut
(11) - Laser
(12) - Clamping nut
(13) - Clamping nut
To Next Page
Loading...
