DURKOPP ADLER 745-35-10 A Service Instructions

Additional equipment
152 Service Instructions 745-35-10 S/745-35-10 A - 02.0 - 04/2017
13.4 Setting the tape feeding and tape cutting device
(745-35-10 A only)
Setting the tape feed
Fig. 132: Setting the tape feeding and tape cutting device (1)
To set the tape feed:
1. Loosen the screws at guides (1), (2) and (3).
2. Set the guides in such a way that the strip is fed precisely.
3. Tighten the screws at guides (1), (2) and (3).
Setting the tape length
The tape length is set at the OP7000 control panel ( p. 172).
WARNING
Risk of injury from moving parts!
Crushing possible.
Do not set the tape feeding and tape cutting device
unless the sewing unit is switched off.
(1) - Guide
(2) - Guide
(3) - Guide
③①
②

DURKOPP ADLER 745-35-10 A Specifications

General

Brand	DURKOPP ADLER
Model	745-35-10 A
Category	Sewing Machine
Language	English