Additional equipment
150 Service Instructions 745-35-10 S/745-35-10 A - 02.0 - 04/2017
13.3 Setting the outfeed roller (745-35-10 A only)
Fig. 131: Setting the outfeed roller
The outfeed roller (part number 0745 598394) is used in combination with
the throw-over stacker. Its application is necessary for workpieces that are
positioned in transverse direction or that are too short to be seized by the
throw-over stacker.
The transport rollers (5) and (7) convey the narrow workpiece to the stack-
er opening of the throw-over stacker.
Important
The transport rollers must be aligned parallel to the tabletop and the mid-
dle of the pocket opening.
Setting the height of the transport rollers
When lowered, both transport rollers (5) and (7) should rest evenly on the
tabletop.
To set the height of the transport rollers:
1. Loosen the hexagon screws (6).
WARNING
Risk of injury from moving parts!
Crushing possible.
Set the outfeed roller only when the sewing unit is
switched off.
(1) - Threaded pin
(2) - Holder
(3) - Throttle valve - lifting speed
(4) - Throttle valve - lowering speed
(5) - Transport roller
(6) - Hexagon screw
(7) - Transport roller
To Next Page
Loading...
Need help?
General
