DURKOPP ADLER 745-35-10 A - 17 Maintenance

Maintenance
Service Instructions 745-35-10 S/745-35-10 A - 02.0 - 04/2017 301
17 Maintenance
This chapter describes maintenance work that needs to be carried out on
a regular basis to extend the service life of the machine and achieve the
desired seam quality.
Maintenance interval
WARNING
Risk of injury from sharp parts!
Punctures and cutting possible.
Prior to any maintenance work, switch off the
machine or set the machine to threading mode.
WARNING
Risk of injury from moving parts!
Crushing possible.
Prior to any maintenance work, switch off the
machine or set the machine to threading mode.
Work to be carried out Operating hours
8 40 160 500
Machine head
Remove fluff, lint and thread remnants 
Check the oil level 
Check the hook lubrication 
Check the lenses for the remaining thread monitor 
Clean the reflecting foils 
Pneumatic system
Check the water level in the pressure controller 
Check the filter element in the maintenance unit 
Check the tightness of the system 
Drive unit and transport carriage
Check state and tension of the toothed belts 
Additional equipment
Clean (blow out) the automatic piping slitting device 