Folder
144 Service Instructions 745-35-10 S/745-35-10 A - 02.0 - 04/2017
Fig. 126: Setting the guide plates at the folder (2)
4. Align the guide plates (2)
5. Loosen the screws (4).
6. Loosen the threaded pin (7).
7. Adjust the guide plates (2) in longitudinal direction.
8. Adjust the threaded pins (6).
The lower edges of the guide plates should be approx. 1 to 2 mm above
the fabric sliding plates.
9. Tighten the screws (4).
10. Tighten the threaded pin (7).
Setting the spring pressure
To set the spring pressure:
1. Loosen the screws (5).
2. Adjust the pressure by aligning the leaf springs (3).
3. Tighten the screws (5).
(3) - Leaf springs
(4) - Screws
(5) - Screws
(6) - Threaded pins
(7) - Threaded pin
To Next Page
Loading...
