Stacker
162 Service Instructions 745-35-10 S/745-35-10 A - 02.0 - 04/2017
4. Switch cam e (8) operating valve 4 (7) must be set such that clamping
bracket b (4) is located outside of the swivel range of throw-over bracket
d (1) when valve 4 (7) is actuated.
5. To adjust switch cam e (8), loosen the screw and turn switch cam e (8)
on the axle.
• Switch actuation point later (+): turn counterclockwise
• Switch actuation point earlier (-): turn clockwise
6. Valve 5 (10) is actuated after throw-over bracket d (1) is swiveled out.
Throw-over bracket d (1) swivels down.
Switch cam g (12) operating valve 5 (10) must be set such that throw-
over bracket d (1) swivels out until the sewing material is safely
thrown over the stacking bracket.
7. To adjust switch cam g (12), loosen the screw and turn switch
cam g (12) on the axle.
• Switch actuation point later (+): turn counterclockwise
• Switch actuation point earlier (-): turn clockwise
8. Valve 3 (11) is actuated as soon as throw-over bracket d (1) swivels
back down.
Clamping bracket b (4) swivels back.
Switch cam h (13) operating valve 3 (11) must be set such that valve
3 (11) is not actuated until throw-over bracket b (1) has moved back
all the way.
9. To adjust switch cam h (13), loosen the screw and turn switch cam h
(13) on the axle.
• Switch actuation point later (+): turn counterclockwise
• Switch actuation point earlier (-): turn clockwise
10. Valve 2 (6) is actuated as soon as clamping bracket b (4) has moved
back down.
Swivel bracket a (5) moves backwards.
Switch cam i (9) operating valve 2 (6) must be set such that clamping
bracket b (4) safely clamps the sewing material in place before swivel
bracket a (5) moves back.
11. To adjust switch cam i (9), loosen the screw and turn switch cam i (9)
on the axle.
• Switch actuation point later (+): turn counterclockwise
• Switch actuation point earlier (-): turn clockwise
The stacking process is complete as soon as swivel bracket a (5) has
moved back to its original position.
To Next Page
Loading...
