DURKOPP ADLER 745-35-10 A Service Instructions

Table of Contents
2 Service Instructions 745-35-10 S/745-35-10 A - 02.0 - 04/2017
4 Transport carriage.................................................................... 75
4.1 Rear end position of the transport carriage ................................ 75
4.1.1 Setting the position of the reference switch in the slotted hole... 76
4.1.2 Setting the distance between switching screw and reference
switch..........................................................................................77
4.1.3 Setting the transport carriage stop .............................................78
4.2 Changing the toothed belt .......................................................... 79
4.3 Setting the toothed belt tension.................................................. 82
5 Transport clamps ..................................................................... 85
5.1 Aligning the transport clamps with the sliding plate edge........... 86
5.2 Setting the stroke height of the transport clamps ....................... 88
5.3 Setting the distance of the transport clamps to the folder sole... 90
5.4 Setting the front end position of the transport clamp.................. 92
5.5 Setting the blowing of the piping strips....................................... 94
6 Corner knives............................................................................97
6.1 Setting the initial position of the corner knives ........................... 97
6.2 Setting the corner knife parameters ........................................... 98
6.3 Checking the corner knife station
(745-35-10 A only, slanted pocket)........................................... 100
6.3.1 Checking the front left corner knife (745-35-10 A only)............ 101
6.3.2 Checking the rear left corner knife (745-35-10 A only)............. 102
6.4 Aligning the corner knife station with the seams....................... 103
6.5 Setting the slant of the corner knife cuts ..................................106
6.6 Replacing corner knives ........................................................... 107
7 Marking lamps ........................................................................ 109
7.1 Aligning the laser modules (745-35-10 S) ................................ 109
7.2 Aligning the laser modules (745-35-10 A) ................................ 111
7.3 Setting the exact position of the laser marking......................... 113
8 Light barriers ..........................................................................115
8.1 Setting the swivel arm .............................................................. 115
8.2 Aligning the light barriers.......................................................... 116
8.2.1 Setting the light barriers for automatic slant detection.............. 120
8.2.2 Setting the light barriers for the left and the right flap rest........ 123
8.3 Setting the light barrier for the flap ........................................... 126
8.4 Aligning the air nozzles for cleaning the reflecting foils............ 126
9 Setting the folding station plate............................................ 127
10 Aligning the machine head.................................................... 129
11 Setting fabric sliding plate and vacuum plate ..................... 133
12 Folder....................................................................................... 135
12.1 Assembling the folder............................................................... 135
12.2 Aligning the folder with the middle of the pocket opening ........ 136
12.3 Setting the stroke movement of the folder................................ 138
12.4 Aligning the folder with the needles.......................................... 141
12.5 Setting the guide plates at the folder........................................ 143
12.6 Setting the folder detection.......................................................145

DURKOPP ADLER 745-35-10 A Specifications

General

Brand	DURKOPP ADLER
Model	745-35-10 A
Category	Sewing Machine
Language	English