DURKOPP ADLER 745-35-10 A - Page 41

Machine head
Service Instructions 745-35-10 S/745-35-10 A - 02.0 - 04/2017 39
Fig. 26: Assembling the needle bar linkage (2)
7. Tighten the guide plate (10) using the screws (9).
8. Insert the needle and align the needle bar linkage (2) with the throat
plate.
9. Tighten the screw (5).
10. Check the height of the needle bar linkage ( p. 40) and check the
lateral alignment with the needle hole ( p. 42).
Fig. 27: Assembling the needle bar linkage (3)
11. Slide the thread advancing device (13) onto pins (15) and (12).
12. Tighten screws (14) and (11).
13. Adjust the thread advancing device (13) ( p. 72).
(9) - Screws (10) - Guide plate
⑨⑩
(11) - Screw
(12) - Pin
(13) - Thread advancing device
(14) - Screw
(15) - Pin
⑫
⑪
⑬
⑮
⑭