Use the UP and DOWN arrow keys to select the desired file number and then
press [ENTER]. Then the test method has been deleted from the inside memory.
Press [RETURN] key at any time if you wish to cancel the method-set deletion
request.
Note: It is a good laboratory practice routinely to remove test method sets
that you no longer use. This ensures that there always available file
numbers to allow the instrument to remember your method for you
automatically.
3.9.3 Autostart Function
The AUTOSTART function allows you to select the operating parameters for a
particular test, so that the test will be initiated automatically at instrument
power-up.
Press [3] on the keyboard to select AutoStart function.
3-66
To Next Page
Loading...
