Dynamica HALO DB-20 - Wavelength Scan; Measurement Parameter Setting

3.4 Wavelength Scan
Select wavelength scan from the Main Menu.
Press
MAIN MENU on the keypad to enter the main menu screen. And then press
2 on the keyboard from the main menu to enter the Wavelength Scan sub menu
which is shown in the illustration below.
11/04/02 9:54 600.0 nm 0.854 ABS
Wavelength Scan
1 Parameter Setup
2 Sample Setup
3 Print Setup
4 System Setup
5 Save Parameter
6 User Baseline
0 Forward
Select Function: _
3.4.1 Measurement Parameter Setting
When the sample is volatile liquid, please must cover the sample cell
with lid. Don’t measure the combustible liquid or gas with this instrument.
Note:
1. Parameter Setup
Press <1> to select parameter setup from the Wavelength Scan Sub Menu and a sub
menu list will appear on the right side of the screen as shown in the illustration
below.
3-20