Dynamica HALO DB-20 - Step by Step Operation

Print Setup Printer Type ESC/P, DPU,PCL3
System
Setup
Lamp change
mode
Lamp change
WL (nm)
D2 lamp
WI lamp
Auto
D2 Lamp Only
WI Lamp Only
325.0~370.0
(±0.1nm)
On / Off
On / Off
Changeover is automatically made
between D2 Lamp and WI Lamp
Using D2 lamp /WI lamp over the
entire wavelength region
Changeover wavelength between
D2 Lamp and WI lamp
Turn on or off the D2 Lamp
Turn on or off the WI lamp
When the sample is volatile liquid, pleas must cover the sample cell with
lid. Don’t measure the combustible liquid or gas with this instrument.
If the sample is spilled over from the sample cell, please blot up
immediately with proper paper or cloth lest eroding the instrument.
Cautions:
3.3.1 Step by Step Operation
3.3.1.1 Parameter Setup
Press <1> to select Parameter Setup from the photometry submenu, the
parameter submenu list appears on the right side of the screen as shown in the
illustration below:
11/11/02 11:35 600.0 nm 0.854 ABS
Photometry
1 Parameter Setup 1 Data Mode ABS
2 Sample Setup 2 WL (nm) 500.0
3 Curve Setup
4 Print Setup
5 System Setup
6 Save Parameter
0 Forward
Select Function: _
1 T% 2 ABS 3 Conc
3-6