Dynamica HALO DB-20 - Change Source Lamp Usage Time

(6) Put back the light source cover. (See Fig. 5-5)
Fig. 5-5
5.2.2 Change Source Lamp Usage Time
After replacement of new WI lamp or D2 lamp, you should clear the lamp usage
time. Press <1> or <2> to reset time of WI lamp or D2 lamp to zero from the
Calibration submenu, time setting submenu will appear on the right of the screen
as shown below.
11/16/02 15:25 600.0 nm 0.854 ABS
Calibration
1 WL Calibration 1 Change New WI Lamp
2 Set Time 2 Change New D2 Lamp
3 Lamp Time WI Lamp Usage (h) 10
4 GLP/GMP D2 Lamp Usage (h) 10
Select Function: _
5-4