Press <6> key to select Save Parameter from the photometry submenu. The
submenu screen is shown as following:
12/11/02 11:35 600.0 nm 0.854 ABS
Photometry
1 Parameter Setup
2 Sample Setup
3 Curve Setup
4 Print Setup
5 System Setup
6Save Parameter
0 Forward
Select Function: _
Use the keypad to select the desired catalog number (1-20), then press ENTER.
If the memory location that you have selected is available, the instrument stores
entire variable set under test name you have specified. If the catalog number you
requested is already full, the following message appears:
Overwrite this File?
To delete the previous test variables and store the new variable set, press
ENTER. To leave the old variables set intact and store new variables in a
different location, press RETURN.
3.3.2 Performing Photometric Measurements
Once the appropriate operating conditions are selected, the system is ready for
measurement.
1. “%T” or “ABS” selected for Data Mode
Press <0> on the keyboard and the variable selection screen will change to the
measurement screen and the following message will appear on the screen:
Insert SAMP and Press Start to Measure:
Press Autozero on the keyboard to begin an autozero first, and then insert the
sample and press START key to begin a photometric measurement. The results
3-12
To Next Page
Loading...
