of measurement (value of absorbance or transmittance) will display on the
screen.
After finishing the measurement, press Clear/Return key to go on other
performance.
11/02/02 11:47 600.0 nm 0.854 ABS
Photometry
ID
1
2
ABS(T%)
Select Function:_
0.103
0.108
If you press CLEAR key right after the measurement without save, such hint
will appear on the screen:
Data Save? Yes: Clear key/ No: Enter key.
To save the measurement, press Clear/Return key and return the last display.
Then select the memory where you want to save the file (Inside memory or
USB). If you do not want to save the measurement result, press Enter key
directly.
2. “Conc” selected for Data Mode
Select “Conc” data mode from item “Parameter Setup”. After parameter being
set up, press <0> on the keyboard and the variable selection screen will change
to the measurement screen on which is shown in the illustration below.
3-13
To Next Page
Loading...
