Dynamica HALO DB-20 - Page 55

Press Autozero on the keyboard to begin an autozero, and then insert the
and
1 Measure 2 Save Inside 3 Save to USB
11/02/02 11:35 600.0 nm 0.854 ABS
Photometry
STD ABS Conc
Insert STD and Press Start to Measure
standard sample 1 and press START. The standard sample 1 is measured
the resultant value is indicated on the screen. In the same manner, repeat
measurement as many time as the specified number of standards. Upon
completion of standard sample measurements, a calibration curve is disp
on the right side of the screen on which is shown in the illustration below.
s, a calibration curve is disp
on the right side of the screen on which is shown in the illustration below.
layed layed
1 Measure 2 Save Inside 3 Save to USB 4 Graph 5 Blank 6 Statistic
12/11/02 13:35 600.0 nm 0.854 ABS
Photometry 0.410
STD ABS Conc
1 -.0068 0.000
2 -.0098 0.050
3 0.203 0.100 ABS
4 0.300 0.150
5 0.410 0.200 -0.068
0
MG/L
0
.
200
Conc = f(ABS) K0 = 0.000 K1 = 0.577 R= 1.000 R2 = 1.000
Select Function: _
3-14