Dynamica HALO DB-20 - Chapter 5 Replacement of Parts; Consumables and Spare Parts; Parts Replacement; Replacement of Light Source Lamp

Chapter 5 Replacement of Parts
5.1 Consumables and Spare Parts
The following parts are consumables. Contact the nearest Dynamica agent before
consuming all of them.
WI Lamp (Tungsten Iodide Lamp): P/N: 25-03-0001
D2 Lamp (Deuterium Lamp): P/N 25-02-0013
Main Power Fuse: P/N 13-02-0004
Table 5-1 Guaranteed life of lamp
Guaranteed
ti
Guaranteed Period
WI Lamp 1000h 6 months after delivery to customer’s
it
D2 Lamp 1000h 6 months after delivery to customer’s
it
5.2 Part Replacement
5.2.1 Replacement of Light Source Lamp
Cautions on Replacement of Lamp
 Do not replace the lamp with the power switch on. Note that high
voltage is applied to the lamp.
High voltage is discharged while the power is turned off.
 Wait for at least 10 minutes after the power switch is turned on.
 Wear clean gloves for mounting a new lamp. Do not leave fingerprints
on the lamp tube wall.
For D
2
lamp, care should be taken to prevent leaving fingerprints on the
protruded sections.
The following shows how to replace the existing lamp with a new one.
(1) Turn off the power switch. Pull off the power cord. Then, wait for at least 20
minutes until the lamp cools down.
5-1