%T: Within a range of 0 to 600.0 in increments of 0. 1.
Response
Three response speeds are available: Fast, Medium and Slow.
Most application requires a “Medium”. For better reproducibility, choose
the slow response parameter. For high-resolution measurement, select
“Fast” response parameter.
Note: The data reading time interval varies depending on the specified scan time.
Determine a period of scan time according to the purpose of measurement. As
the scan time increase, data is smoothed more to reduce noise.
Scan Time (sec) Reading Interval (sec)
Scan time < 100 0.1
100 ≤ Scan time < 200
0.2
200 ≤ Scan time < 500
0.5
500 ≤ Scan time < 1000
1.0
1000 ≤ Scan time < 2000
2.0
1000 ≤ Scan time < 5000
5.0
5000 ≤ Scan time < 9999
10.0
Scan time ≥ 10000
100.0
2. Sample Setup
Press <2> to select sample setup from the Time Scan Sub Menu and a sub menu
list will appears on the right side of the screen as shown in the illustration below.
These parameters are the same as 3.3.
11/14/02 11:26 600.0 nm 0.854 ABS
Time Scan
1 Parameter Setup 1Name SAMP-1
2 Sample Setup 2 Path Length (nm) 10.0
3 Print Setup
4 System Setup
5 Save Parameter
0 Forward
Input Name:_
3-36
To Next Page
Loading...
