Easy xLogic User Manual

112
112
112
112
triggering signal at input Trg (=analog comparator output) is longer than the on-delay time.
Using this method, you will obtain a virtual hysteresis and reduce the input response to short
signals.
Function
Function
Function
Function block
block
block
block diagram
diagram
diagram
diagram
4
4
4
4 .4.22
.4.22
.4.22
.4.22 Analog
Analog
Analog
Analog threshold
threshold
threshold
threshold trigger
trigger
trigger
trigger
Short
Short
Short
Short description
description
description
description
The output is set or reset depending on two configurable thresholds (hysteresis).
Parameter
Parameter
Parameter
Parameter On
On
On
On and
and
and
and Off
Off
Off
Off
The On and Off parameters can be provided by the actual value of another
already-programmed function:
Analog comparator: Ax – Ay
Analog trigger: Ax
Analog amplifier: Ax
Analog multiplexer: AQ
Analog ramp: AQ
Connection
Connection
Connection
Connection Description
Description
Description
Description
Input Ax
Ax
Ax
Ax Input the analog signal to be evaluated at input Ax.
Use the analog inputs AI1...AI8, the analog outputs AQ1
and AQ2.
0 - 10 V is proportional to 0 - 1000 (internal value).
Parameter A:
A:
A:
A: Gain
Range of values: ± 10.00
B:
B:
B:
B: Zero offset
Range of values: ± 10,000
On:
On:
On:
On: On threshold
Range of values: ± 20,000
Off:
Off:
Off:
Off: Off threshold
Range of values: ± 20,000
p:
p:
p:
p: Number of decimals
Range of values: 0, 1, 2, 3
Output Q
Q
Q
Q Q is set or reset depending on the set thresholds.

Easy xLogic Specifications

General

Brand	Easy
Model	xLogic
Category	Control Unit
Language	English