Easy xLogic User Manual

66
66
66
66
4
4
4
4 .4.1
.4.1
.4.1
.4.1 On-delay
On-delay
On-delay
On-delay
Short
Short
Short
Short description
description
description
description
The output is not switched on until a configured delay time has expired.
Connection
Connection
Connection
Connection Description
Description
Description
Description
Trg
Trg
Trg
Trg input The on delay time is triggered via the Trg (Trigger) input
Parameter T
T
T
T represents the on delay time after which the output is
switched on (output signal transition 0 to 1).
Retentivity
Retentivity
Retentivity
Retentivity on = the status is retentive in memory.
Output Q
Q
Q
Q Q switches on after a specified time T has expired, provided Trg
is still set.
Parameter
Parameter
Parameter
Parameter T
T
T
T
The time for parameter T can also be preset based on the actual value of another, already - configured
function. You can use the actual values of the following functions:
Analog comparator: Ax - Ay
Analog trigger: Ax
Analog amplifier: Ax
Analog multiplexer: AQ
Analog ramp: AQ
Analog math: AQ
PI controller:AQ
Data latching relay: AQ
Up/Down counter: Cnt
You select the required function via the block number. Time-base can be adjusted.
The value of ＂ T ＂ can be set/modified in parameter mode. For information about how to
modify ， refer to chapter 5 .2.2 please.
For information on the validity and accuracy of the time base, refer to the xLogic time-base list
as follows:
Valid
Valid
Valid
Valid ranges
ranges
ranges
ranges of
of
of
of the
the
the
the time-base,
time-base,
time-base,
time-base, if
if
if
if T
T
T
T =
=
=
= parameter
parameter
parameter
parameter
Time-base
Time-base
Time-base
Time-base Max.
Max.
Max.
Max.
value
value
value
value
Min.
Min.
Min.
Min. resolution
resolution
resolution
resolution Accuracy
Accuracy
Accuracy
Accuracy
s (seconds) 99:99 10 ms ±
±
±
± 10 ms
m (minutes) 99:59 1s ± 1 s
h (hours) 99:59 1 min ± 1 min

Easy xLogic Specifications

General

Brand	Easy
Model	xLogic
Category	Control Unit
Language	English