Easy xLogic User Manual

211
211
211
211
7
7
7
7 .1
.1
.1
.1 Connecting
Connecting
Connecting
Connecting the
the
the
the xLogic
xLogic
xLogic
xLogic to
to
to
to a
a
a
a PC
PC
PC
PC
Connecting
Connecting
Connecting
Connecting the
the
the
the PC
PC
PC
PC cable
cable
cable
cable
To connect the xLogic to a PC, you need the xLogic PC cable (ELC-RS232).
Remove the cap from your xLogic and connect the cable to the communication port. Connect
the other end of the cable to the serial port of your PC.
Connecting
Connecting
Connecting
Connecting the
the
the
the PC
PC
PC
PC cable
cable
cable
cable to
to
to
to the
the
the
the USB
USB
USB
USB port
port
port
port
If your PC is only equipped with a USB interface (Universal Serial Bus), you will need a ELC-USB
module to connect the xLogic cable to this port. For the ELC-USB module information, refer to
Chapter 1.
Note
Note
Note
Note
If the circuit program created with xLogic
xLogic
xLogic
xLogic is password protected, both the circuit program and
the password are downloaded to xLogic. The password prompt is enabled at the end of the data
transfer. The upload of a password protected program created in xLogic is only possible after
the correct password is entered in xLogic.
xLogic.
xLogic.
xLogic.

Easy xLogic Specifications

General

Brand	Easy
Model	xLogic
Category	Control Unit
Language	English