Eaton 9130 - Page 36

Operation
Eaton 9130 700/3000 VA UPS User’s Guide 164201718—Rev 7 www.eaton.com/powerquality 30
Number of Battery Strings [0] [1] [2] … [10]
See “Configuring the UPS for EBMs”on page 36.
1
Battery Charge Mode [ABM Cycling] [Constant] ABM Cycling
Temperature Compensated Charging [Enabled] [Disabled]
If Disabled, the default charger voltages for 25C
(77F) are assumed.
Enabled
Battery Charge % to Restart [Not Checked] [10] [20] … [100]
If a percentage is selected, automatic restart (if
enabled) occurs when the battery's charge reaches
the selected level.
Not Checked
Battery Low Alarm [Immediate] [2 min] [3 min] [5 min]
The “Battery Low”alarm triggers when the set
amount of backup time (approximately) remains in
the batteries. If set to Immediate, the alarm
activates at the same time as the “UPS on Battery”
notice.
3 min
Automatic Battery Support Tests [Enabled] [Disabled]
See “Running Automatic Battery Tests”on
page
36.
Enabled
Ambient Temperature Warning [Enabled] [Disabled] Enabled
Predictive Maintenance Notices [Enabled] [Disabled] Enabled
Remote Emergency Power-off (REPO)
Input Polarity
[Open] [Closed] Open
Logic Power Off [0] [1...120 min]
See “Logic Power Off” on page 33.
0 min
Table 3. User Settings (Continued)
Description Available Settings Default Setting
NOTE * See “Configuring Bypass Settings”on page 34.
NOTE ** The cXSlot Signal setting is for a communication card. The cXSlot Serial setting is for the relay card.