113
EA(B)O-6X06 01/2018 Rev. 1 3. Disassembly and Assembly
6370
End Play Adjustment
6. Insert a pry bar through the PTO opening and, with the
pry bar supported on the transmission case and applying
the force under the gear, push the countershaft upward at
once. Read the countershaft end play in the dial indicator.
7. If the countershaft end play reading in the dial indicator
is within the specied limits, go back to the transmission
assembly and continue from the point where the
assembly was stopped. Otherwise, determine the shim
pack thickness needed to adjust the countershaft end
play before proceeding.
8. If necessary to remove or add shims to adjust the
countershaft end play, refer to “Rear Case, Disassembly
and Assembly” in this manual for instructions on how to
remove and install the countershaft rear bearing cup.
To Next Page
Loading...
