137
EA(B)O-6X06 01/2018 Rev. 1 4. Electro-Hydraulic Control Unit
5. Release the pressure sensor connector.
0013-18
Assembly
1. Install the harness clamps and secure it through the
three Torx screws, applying the specied torque.
6. Using a Torx T20 wrench, loosen the bolts from the
three clamps which attach the harness to the housing
and remove the complete harness.
2. Apply 0.4g of Nyogel on pressure sensor and connect
it.
0015-18
0016-18
0014-18
Pay attention to the correct mounting
position of the clamps on the harness
since they have dierent diameters and
positions.
Electro-Hydraulic Control Unit
Disassembly and Assembly
To Next Page
Loading...
