98
3. Disassembly and Assembly 01/2018 Rev. 1 EA(B)O-6X06
15. Install the reverse shift yoke together with the reverse
coupling sleeve.
6009
11. Place the front case with its front side (bell housing)
facing down on the stand mounting bracket and secure
the case with at least three capscrews.
12. With a hoist, lift shafts and shift rails assembly from the
special base and position the assembly over the front
case.
14. After seating the shafts and rails assembly into the case,
cut and remove the strap used to hold them together and
untie the strings used to secure the input shaft and pull
them out.
13. Carefully, lower the shafts and shift rails assembly into
the front case.
6570
6575
6578
Transmission Assembly
To Next Page
Loading...
